Tork Craft | Mini Tungsten Carbide Cutter 2,4mm Type_Dust Extraction A compressor is required with

A compressor is required with an air flow delivery of at least 100l/min at 6

Extra-Fine diamond (9 micron / 1200 mesh) to polish and refine a razor edge after sharpening with a coarser diamond

FastFix interface on the cordless drill for rapid change of attachments within seconds without the need for any tools

margin:0 0 10px}

Tork Craft | Mini Tungsten Carbide Cutter 2,4mm Type_Dust Extraction A compressor is required withMini Tungsten Carbide Cutter The tungsten carbide cutter has greater edge retention when compared to a steel cutter and can be used for material removal, shaping and smoothing on hard materials The cutter can be used on the following materials: Hardened and stainless steel Cast iron Non ferrous metals Fired ceramic Wood Plastic Qty: 1 NB: When shaping material, remove small amounts, instead of large chucks. This will increase the life of the cutter