10"X 80T Melamine Blade, -5 Degree 5/8" Bore, H-ATB PT01-03 Pre-drill and countersink to drive

Pre-drill and countersink to drive screws flush with the material surface or deep hole counter boring for driving screw heads below the surface

and it will hone bevel angles from 15° to 54° and back bevels from 10° to 20°

which promotes a better fit to the taper on the headstock of the lathe

or checking flatness

10"X 80T Melamine Blade, -5 Degree 5/8" Bore, H-ATB PT01-03 Pre-drill and countersink to driveDesigned for cutting double sided melamine and veneered sheet goods on saws without a scoring unit. The H ATB tooth geometry slices clearly through fragile coatings and laminates. The high bevel will not "violate" the bottom laminate upon exiting the cut, which causes "blow out". Extra hard sub micrograin carbide tips for long life. Smooth, clean cuts in double sided melamine MD10 803 Carbide Tipped Double Sided Melamine 10 Inch Dia x 80T H ATB, 5